top of page
IMG_7322.jpg
Title_Delta_map.png

ARGO

그저 가만히 서서, 당신을 바라볼 뿐.

Sculptor. 이얼리 (yearly)  / Makeup.  ERRORCODE13 / clothes.  LOCOPERRO

모든것이 끝나고 남은것은
세상을 ​불태울듯이 뜨거웠던 그날의 불꽃이 짓눌러버린 상흔과
​남김없이 흩어져 사라져버린 마음뿐.

 

A1_1_DSC00195-1.jpg
A1_1_IMG_7288-1.jpg
A1_8_IMG_7364-2IMG_7357-1.jpg
A1_7_IMG_7405-2.jpg
A1_6_IMG_8_7403_1.jpg
A1_6_DSC00282-1.jpg
IMG_7211_2.jpg
IMG_7221-2.jpg
IMG_7248-2.jpg
IMG_7233_2.jpg
IMG_7204-2.jpg
IMG_7254-2.jpg

Special thank you to B2SHOP!

DSC00948-2.jpg
IMG_9850-2.jpg
DSC00935-2.jpg

1/6 의상이 호환 가능합니다.

다만, 브랜드나 사이즈에 따라 핏이 다를 수 있으며, OBITSU 27 바지의 경우 밴드 바지는 타이트하거나 작을 수 있습니다.( 고무줄 바지 추천)​

 

1/6 Costumes are compatible.

However, the fit may vary depending on the brand or the specification, and for OBITSU 27 pants, band pants may be tight or small.

(Rubber band pants recommended)

HEAD INFORMATION

IMG_6819_2.jpg

 아르고 베이직 패키지 : 300,000₩

헤드,바디(발파츠 2종류 중 택 1),인증서

Argo basic package: 250$

IMG_6815.jpg

 아르고 풀 패키지: 370,000₩ 

헤드,바디(발파츠 2종류중 택1),머리카락 파츠,인증서

Argo full package: 308$

헤드둘레 : 5 인치 

스킨색상 : 노멀, 페이퍼 화이트 (2종류)

착용 안구 : 10mm (네로우 추천)

*헤어파츠 부착을 위해

헤드 뚜껑 면과 헤드 안쪽에 자석이 부착되어 있습니다.

​​

Head : 5 inch 

Skin Color : Normal, Paper White skin. (2 types)

Eyeball used: 10 mm (recommend the 'narrow eye')

*Magnets are attached to the back of the head lid.

아르고 헤드 단품 : 90,000₩ 

​아르고 헤어파츠 단품 :70,000₩

ARGO head : 75$ 

ARGO hair parts : 58$ 

DSC00294_edited_edited.jpg

❗️헤어파츠를 조금 더 타이트하게 맞추고 싶으신 경우 블루텍을 이용하여 주세요.❗️

아르고는 헤어파츠가 다른 인형에 비해 타이트하고 얇게 디자인되어 있습니다.

때문에 기온 상황에 따라 약간의 수축이 있을 수 있으니, 너무 빡빡하여 조립이 어려운 경우

화상을 입지 않게 조심하며 뜨거운 물 또는 드라이기를 이용하여 헤어파츠에 살짝 열을 주어 조립해 주세요.

If you want to fit it a little tighter, please use Blutack.

Argo's hair parts are designed to be tight and thinner than other dolls.

Therefore, there may be some shrinkage depending on the temperature situation, so if it is too tight to assemble,

Be careful not to get burned and assemble the hair part with a little heat using hot water or a dryer.

MAKE-UP INFORMATION

IMG_7183_2.jpg
IMG_7179-2.jpg

DEFALT MAKE UP-A

make up by ERRORCODE13

디폴 메이크업 A: 55,000 ₩

Default makeup A : 46$

디폴 헤어도색 A: 48,000 ₩

Default Hairpaint A : 40$

* 화상 흉터 없는 옵션 선택이 가능합니다.

*You can choose the option of no burn scars.

* 개별/교차 선택이 가능합니다.

*Individual/cross selection is available.

*페이퍼 화이트 스킨에도 적용이 가능합니다.

다만,기존 메이크업과 동일한 결과를 얻을 수 없습니다.

스킨톤에 맞추어 쉐딩 등을 커스텀하지 않습니다.

*It can also be applied to paper white skin.

however, we cannot achieve the same results as conventional makeup.

We don't customize the shading according to the skin tone.)

MAKE-UP INFORMATION

IMG_7263_2.jpg
IMG_7257_2.jpg

DEFALT MAKE UP-B

make up by YEARLY

디폴 메이크업 B: 45,000 ₩

Default makeup B : 37$

디폴 헤어도색 B: 35,000 ₩

Default Hairpaint B: 29$

* 개별/교차 선택이 가능합니다.

*Individual/cross selection is available.

*노멀 스킨에도 적용이 가능합니다.

다만,기존 메이크업과 동일한 결과를 얻을 수 없습니다.

스킨톤에 맞추어 쉐딩 등을 커스텀하지 않습니다.

*It can also be applied to normal skin.

however, we cannot achieve the same results as conventional makeup.

We don't customize the shading according to the skin tone.)

SKIN OPTION

​주문 가능 스킨 :  페이퍼 화이트, 노멀.

Available to order skin: paper white, normal.

*헤어파츠와 치아, 혀 파츠는 페이퍼 화이트 컬러로만 제작됩니다.

*Hair parts, teeth, tongue parts are only made in paper white color.

​모니터 및 액정상황에 따라 스킨 색이 달라보일 수 있습니다. 단순 참고용으로만 이용하여 주십시오.

The skin color may look different depending on the monitor and screen type. Please use it only for just reference.

​-색이 진한 컬러의 파츠의 경우, 복제 과정 중 퍼팅라인, 마블링, 작은 점, 다듬은 자국 등이 발생하며, 이것은 불량이 아닙니다.

-In the case of dark colored parts, putting lines, marbling, small dots, trim marks, etc. occur during the replication process. This is not defective.

-복제 과정에서 미세한 기포등이 발생할 수 있습니다. 눈에 띄는 위치(안면부 등)의 기포가 아니라면 불량이 아닙니다.

Small air bubbles may occur during the casting process. Unless they are in highly visible areas (such as the face), they are not considered defects.

BODY OPTION

IMG_6815_2.jpg

옵션파츠-장갑 손파츠를 착용하고 촬영하였습니다. (별도 구매)

I took a picture after wearing Option Parts-Gloves Parts. (Buy separately)

Average Height with head :  33cm(no hair parts) 

 ,37cm(with hair, horn parts)

Neck : 4.8cm

Shoulder width : 7.5cm

Bust : 12cm

Waist : 8.7 cm

Hip : 13.7cm

BODY DETAIL

입체물이므로 재는 위치에 따라 사이즈가달라질 수 있습니다. 단순 참고로만 이용해 주십시오.

Since it is a three-dimensional object, the size may vary depending on the location of measurement. Please use it as a simple reference.

Please refer to this post for information on body parts.

​바디에 대한 정보는 이 게시물을 참고해 주십시오.

Please check!

​아르고는 발파츠를 2종류중 1개로 선택해 주셔야 합니다.

1/6사이즈 신발이 호환되는 1/6사이즈 발과, USD사이즈의 신발이 호환되는 베이직 발파츠중 한가지를 선택해서 주문해 주십시오.

For ARGO, you have to choose one of the two types of foot parts. 

Please choose one of the '1/6 foot' parts that are compatible with size 1/6 shoes,

or the 'basic foot' parts that are compatible with USD shoes.

-동시기에 복제된 인형이 아니거나, 다른 타입의 인형에게 착용시킬 경우, 착용이 불가능하거나 뜨거운 물 등으로 커스텀이 필요할 수 있습니다.

-헤어파츠가 신너에 장시간 노출될 경우 수축이 발생할 수 있습니다. 이로 인해 인형 착용에 지장이 생길 수 있으므로 신너 사용 시 주의해 주세요.

수축이 발생한 경우 뜨거운 물 등을 이용하여 형태를 조정할 수 있습니다.

-복제 시기별로 색상이 다르기 때문에 동시에 생산된 제품이 아닐경우 색차가 발생할 수 있습니다.

-타 회사의 인형과 호환 정보를 확인할 수 없어 안내가 불가능합니다.

-진한 색의 원단으로 제작된 의상은 장시간 착용시 이염을 발생시킬 수 있습니다.

주의하여 주십시오.

​-실물 스킨색은 모니터에서 보이는 색상과 다를 수 있습니다

-복제 과정에서 미세한 기포등이 발생할 수 있습니다. 눈에 띄는 위치(안면부 등)의 기포가 아니라면 불량이 아닙니다.

-​색이 진한 컬러의 파츠의 경우, 복제 과정 중 퍼팅라인, 작은 기포, 마블링, 작은 점, 다듬은 자국 등이 발생하며, 이것은 불량이 아닙니다.

-If the hair parts are fitted to dolls that were not cast at the same time or to a different type of doll, they may not fit properly and could require customization using hot water or other methods.

-Prolonged exposure to thinner may cause the hair parts to shrink, which may affect their fit on the doll. Please use caution when using thinner.If shrinkage occurs, the shape may be adjusted using hot water or other appropriate methods.

-Color differences may occur if the product is not produced at the same time because the color varies according to the replication period.

-We cannot confirm the size of other companies' dolls, so we cannot inform them of their wearability.

-Clothes made of dark-colored fabric can cause stains when worn for a long time. Please be careful.

-The actual skin color may differ from the color seen on the monitor.

-Small air bubbles may occur during the casting process. Unless they are in highly visible areas (such as the face), they are not considered defects.

--In the case of dark colored parts, putting lines, Small bubble,  marbling, small dots, trim marks, etc. occur during the replication process. This is not defective.

Project delta

Director  Jang Lee-Eul

Contact / QNA projectdelta_bjd@naver.com

Business Registration Number 854-19-01112
E-Commerce Number 2019-경기양평-238 [조회]

Adress 22, Mogwangni-gil 137beon-gil, Yangseo-myeon, Yangpyeong-gun, Gyeonggi-do, Korea

​© 2022 Project delta. All rights reserved.

  • 화이트 트위터 아이콘
  • 화이트 인스 타 그램 아이콘
bottom of page